Nuwriter doesn't know SD or eMMC?

[jie-ss]

I built a image with the config "ma35d1_sdcard0" and downloaded it by NuWriter, however, it was downloaded to SD card but not eMMC. I must remove the SD card before downloading then the image would be downloaded to eMMC.

ps: sdcard0 is eMMC and sdcard1 is SD card slot, right? for HMI MA35D1 S1

[hpchen0]

1. What is the "power on setting" configuration on the board?
2. For the NuMaker-HMI-MA35D1, "sdcard0" refers to the SD card, while "sdcard1" refers to the eMMC.

[jie-ss]

1. power on setting is 00001101, so even in USB booting, PG6 is still used?

2. well, my mistake. so I should name it with ma35d1_sdcard1 in the config.