diff --git a/makefiles/default-radio-settings.inc.mk b/makefiles/default-radio-settings.inc.mk
index 0ffdcb252354..8ef276ac3778 100644
--- a/makefiles/default-radio-settings.inc.mk
+++ b/makefiles/default-radio-settings.inc.mk
@@ -1,17 +1,26 @@
-# Set a custom channel if needed
-ifneq (,$(DEFAULT_CHANNEL))
-  ifneq (,$(filter cc110x,$(USEMODULE)))        # radio is cc110x sub-GHz
-    CFLAGS += -DCC110X_DEFAULT_CHANNEL=$(DEFAULT_CHANNEL)
+# Frequency Band (FBAND) variable can pass like: make BOARD=samr30-xpro FBAND=868 flash term
+# with FBAND=868 changes channel/page setting only if transceiver is at86rf212b
+ifndef CONFIG_KCONFIG_MODULE_IEEE802154
+  ifeq (868, $(FBAND))
+    # radio is at86rf212b sub GHz at FBAND=868MHz (channel = 0 / page = 0)
+    ifneq (,$(filter at86rf212b,$(USEMODULE)))
+      CFLAGS += -DCONFIG_IEEE802154_DEFAULT_SUBGHZ_CHANNEL=0
+      CFLAGS += -DCONFIG_IEEE802154_DEFAULT_SUBGHZ_PAGE=2
+    # if not using samr30-xpro radio is the same as default IEEE 802.15.4 2.4 GHz
+    else
+    # radio is IEEE 802.15.4 2.4 GHz
+      GHZ_CHANNEL ?= 26
+      CFLAGS += -DCONFIG_IEEE802154_DEFAULT_CHANNEL=$(GHZ_CHANNEL)
+    endif
+  # Applying default setting if FBAND is 915MHz (Channel = 26 for 2.4 GHz, Channel = 5/Page = 2 for sub-GHz)
+  else
+    ifneq (,$(DEFAULT_CHANNEL))
+      ifneq (,$(filter cc110x,$(USEMODULE)))# radio is cc110x sub-GHz
+        CFLAGS += -DCONFIG_CC110X_DEFAULT_CHANNEL=$(DEFAULT_CHANNEL)
+      endif
+    endif
   endif
-
-  ifneq (,$(filter at86rf212b,$(USEMODULE)))    # radio is IEEE 802.15.4 sub-GHz
-    CFLAGS += -DIEEE802154_DEFAULT_SUBGHZ_CHANNEL=$(DEFAULT_CHANNEL)
-  else                                          # radio is IEEE 802.15.4 2.4 GHz
-    CFLAGS += -DIEEE802154_DEFAULT_CHANNEL=$(DEFAULT_CHANNEL)
+  ifneq (,$(DEFAULT_PAN_ID))
+    CFLAGS += -DCONFIG_IEEE802154_DEFAULT_PANID=$(DEFAULT_PAN_ID)
   endif
 endif
-
-# Set a custom PAN ID if needed
-ifneq (,$(DEFAULT_PAN_ID))
-  CFLAGS += -DIEEE802154_DEFAULT_PANID=$(DEFAULT_PAN_ID)
-endif