Preview/Print Seam Location Mismatch

[mcallis47]

Describe the bug
I'm printing a basic xyz calibration cube and the seams are not printing in the correct locations. When set to "Nearest", "Back", or "Aligned", the preview shows many or all of the seams in the corners, but they print in the center of the faces instead. After rotating the cube 45 degrees, the "Back" position still printed seams at the center of a face (the left-rear face) instead of the corner that was now directly facing the back.

3mf File for This Bug
If it is related to slicing, please append the 3mf file. It could be extremely helpful to solve the issue.
cube.zip

To Reproduce
Steps to reproduce the behavior:

1. Import calibration cube
2. Set Seam position to "Back"
3. Note location of seam in slicer (back right corner)
4. Print
5. Note location of seam on actual cube (right down the middle of rear face)

Expected behavior
The print should match the slicer preview

Screenshots

Desktop (please complete the following information):

• OS: Windows 10
• Version 22H2

[mcallis47]

[mcallis47]

After further investigation, this appears to not be slicer related, as it's new to me as of the last update, but now also occurs in the previous versions of the slicer. It's not actually a seam, but a weird "blip" that appears about 10mm after every seam.