“Extra Infill Lines To Support Skins” for supports also. Especially tree supports.

[spiritparticle]

Is your feature request related to a problem?

The issue of the lines not having support is not just an infill only situation. It occurs very often when using certain types of support in combination with certain models. And almost ALWAYS happens when using tree supports. I would just like the feature available for support material too not just infill. And I was kind of surprised it wasn't included in the support section too since it solves the same issue for support structures.

Describe the solution you'd like

A “Extra Infill Lines To Support Skins” checkbox that does the same operation in the Supports section too.

Describe alternatives you've considered

The alternative is to increase the support density for the "infill" of tree supports but the material use goes way up. When it could be simply done in the same way as “Extra Infill Lines To Support Skins” does to the infill.

Affected users and/or printers

All users who want to use tree infill and have a low or 0% infill on tree supports. Adding the feature that is already implemented in the infill to the supports system too will solve the issue.

Additional information & file uploads

No response