main.h

#include <18F452.h>
#device adc=16

#FUSES NOWDT                 	//No Watch Dog Timer
#FUSES WDT128                	//Watch Dog Timer uses 1:128 Postscale
#FUSES HS                    	//High speed Osc (> 4mhz for PCM/PCH) (>10mhz for PCD)
#FUSES NOOSCSEN              	//Oscillator switching is disabled, main oscillator is source
#FUSES NOPUT                 	//No Power Up Timer
#FUSES NOBROWNOUT            	//No brownout reset
#FUSES BORV20                	//Brownout reset at 2.0V
#FUSES STVREN                	//Stack full/underflow will cause reset
#FUSES NOLVP                 	//No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O
#FUSES NODEBUG               	//No Debug mode for ICD
#FUSES NOPROTECT             	//Code not protected from reading
#FUSES NOCPB                 	//No Boot Block code protection
#FUSES NOCPD                 	//No EE protection
#FUSES NOWRT                 	//Program memory not write protected
#FUSES NOWRTC                	//configuration not registers write protected
#FUSES NOWRTB                	//Boot block not write protected
#FUSES NOWRTD                	//Data EEPROM not write protected
#FUSES NOEBTR                	//Memory not protected from table reads
#FUSES NOEBTRB               	//Boot block not protected from table reads

#use delay(clock=10000000)
#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8,stream=PORT1)