Cursor jumps twice in consoles

[nvaccessAuto]

Reported by tspivey on 2015-02-06 07:40
STR:

1. Make sure caret moves review cursor is on.
2. Open cmd.
3. Type echo, press enter, then immediately move the cursor to the previous line.
   Expected:
   NVDA will say blank, and stay there.
   Actual:
   NVDA says blank, but my review cursor will sometimes move back to the input line if I'm too fast.

[LeonarddeR]

CC @tspivey: How is this nowadays?

[tspivey]

I still have this issue.

[LeonarddeR]

Do you also have the idea that it happens more often now? I think it does, as this would be an expected regression of increasing the caret timeout (#7201)

[Adriani90]

@tspivey did you take further tests regarding this issue? Is it now happening much more often than in nvda 2017.2 or earlier?

[Adriani90]

@tspivey just ro remind you, could you respond to the comment above? Do you still see this issue in NVDA 2019.3 RC3?

[tspivey]

Yes, I still see it, and don't know if it happens more often.

[Adriani90]

@tspivey could you test with NVDA 2024.1 RC1? Are you still seeing this issue? Also is there a difference when using UIA vs. not using UIA in consoles?

[tspivey]

This is still an issue, and UIA on or off doesn't make a difference.