斐讯T1使用armbian_aml_s912_buster_*.img镜像 armbian-config命令报错

[aachuanga]

斐讯T1使用armbian_aml_s912_buster_*.img镜像 armbian-config命令报错

[ophub]

What's wrong?

[aachuanga]

怎么了？

Error opening terminal：unknown
‘unknown’：I need something more specific.

[ophub]

input the command: armbian-config

My test is normal.
You try today's latest two different kernel versions of 5.4 and 5.10.

[aachuanga]

input the command: armbian-config

My test is normal. You try today's latest two different kernel versions of 5.4 and 5.10.

Install the latest system. The armbian-config command is normal, but the wired network card cannot obtain IP

[ophub]

You need to connect the box to the router and let the router assign IP.

Connect to the router and restart, check the IP of the device named armbian in the router.

[aachuanga]

You need to connect the box to the router and let the router assign IP.

Connect to the router and restart, check the IP of the device named armbian in the router.

The router is normal, and the devices under the router can obtain the IP normally, that is, the phicomm T1 cannot obtain the IP. After restarting, the IP can be obtained, but the IP can not be obtained after restarting again. You need to restart the wired network port twice to get the IP. However, WiFi is not affected, and IP can be obtained normally using WiFi. Could it be that T1 is not well adapted?

[ophub]

Try another network cable, it may be a bad connection. Observe more.

[aachuanga]

尝试另一根网线，可能是连接不良。多观察。

I still can't replace the network cable, and I think it's faster than the armbian_ 5.91 slow