Starting LoRa failed using LoRa shield LA66

[skyeee21]

Are you receiving Starting LoRa failed while using the demo code?

PLEASE see the FAQ #1 about using setPins BEFORE submitting an issue.

Hi please help me solve the problem. I'm using LoRa shield LA66 Dragino with RFM95. And I keep getting "Starting LoRa failed!" on my serial monitor. I even tried a simple test code yet, result is still the same. Here is my code and wiring diagram, I made sure that the connection is correct, plus the LoRa shield is blinking so I doubt if it was damaged. Anyone has solve this problem? I'm also using 915MHz

// Add the LoRa library
#include <LoRa.h>
#include <SPI.h>
#include "DHT.h"

#define DHTPIN 7 // Pin where the sensor is connected
#define DHTTYPE DHT11 // Type of the DHT sensor

DHT dht(DHTPIN, DHTTYPE); // Create the DHT object

void setup() {
Serial.begin(9600);
while (!Serial);
Serial.println("LoRa Sender Test");

dht.begin(); // Initialize the DHT sensor
if (!LoRa.begin(915E6)) {
Serial.println("Starting LoRa failed!");
while (1);
}

}
void loop() {

float humidity = dht.readHumidity();
float temperature = dht.readTemperature();

// Display valid readings
Serial.print("Humidity: ");
Serial.print(humidity);
Serial.print("% Temperature: ");
Serial.println(temperature);

// Transmit the LoRa packet
LoRa.beginPacket();
LoRa.print(humidity);
LoRa.print(temperature);
LoRa.endPacket();
delay(30000);
}

[sercero]

It seems as if the shield is not connected all the way....