Bluetooth: hci_bcm: Streamline runtime PM code

This driver seeks to force the Bluetooth device on for the duration of
5 seconds when the Bluetooth device has woken the host and after a
complete packet has been received.  It does that by calling:

    pm_runtime_get();
    pm_runtime_mark_last_busy();
    pm_runtime_put_autosuspend();

The same can be achieved more succinctly with:

    pm_request_resume();

That's because after runtime resuming the device, rpm_resume() invokes
pm_runtime_mark_last_busy() followed by rpm_idle(), which will cause
the device to be suspended after expiration of the autosuspend_delay.

No functional change intended.

Cc: Frédéric Danis <[email protected]>
Signed-off-by: Lukas Wunner <[email protected]>
Signed-off-by: Marcel Holtmann <[email protected]>

drivers/bluetooth/hci_bcm.c

@@ -191,9 +191,7 @@ static irqreturn_t bcm_host_wake(int irq, void *data)
 
 	bt_dev_dbg(bdev, "Host wake IRQ");
 
-	pm_runtime_get(bdev->dev);
-	pm_runtime_mark_last_busy(bdev->dev);
-	pm_runtime_put_autosuspend(bdev->dev);
+	pm_request_resume(bdev->dev);
 
 	return IRQ_HANDLED;
 }
@@ -512,11 +510,8 @@ static int bcm_recv(struct hci_uart *hu, const void *data, int count)
 	} else if (!bcm->rx_skb) {
 		/* Delay auto-suspend when receiving completed packet */
 		mutex_lock(&bcm_device_lock);
-		if (bcm->dev && bcm_device_exists(bcm->dev)) {
-			pm_runtime_get(bcm->dev->dev);
-			pm_runtime_mark_last_busy(bcm->dev->dev);
-			pm_runtime_put_autosuspend(bcm->dev->dev);
-		}
+		if (bcm->dev && bcm_device_exists(bcm->dev))
+			pm_request_resume(bcm->dev->dev);
 		mutex_unlock(&bcm_device_lock);
 	}