Orbion Hardware Rev. 2.5

New add

• Other 2 rear button
• Insert for reset button
• Timeout display and Neopixels (Default set 1min)
• Two version for right-handed & left-handed (Top_Left or Top_Right file)
• New support for USB type interchangeable
• Different method for inserting the OLED display
• Axial bearing in the knob to avoid strange oscillations
• Clip to secure cables in place
• multiple cable routes for the Arduino support
• new knob hooking system to prevent deformed prints

Fixed

• wobbly knob rotation
• display attachment system not always compatible and unstable

All the parts can be printed in the material of your choice except the Wire_clips and cuschion which must be exclusively in TPU Shore 95A or 85A.

The Spacers must also be printed, they will be positioned as the last component after inserting the knob_support on the D-shaft. Any rigid material is fine

The Top_Left and Top_Right versions are to be printed based on whether you are right-handed or left-handed.