REV Hub Serial Protocol Analyzer

Usage

This analyzer has only been tested with the UART version of the protocol, not the RS-485 version. However, the RS-485 version should work fine as well. See Saleae's Decode RS-232, RS-485, & RS-422 page.

1. Set up an Async Serial analyzer (or two if you want to analyze traffic in both directions when using UART) at 460800 baud, with otherwise default settings
2. Set up a REV Hub Serial Protocol analyzer for each Async Serial analyzer (for firmware 1.8.2, the DEKAInterfaceFirstId should be set to 4096)