Optimize ArchDepth and Hook perameters for Ezh-derived letters. #2602
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Ideally I would like to show before and after images of three weights each of both widths of monospace, both upright and italic, both sans and slab, and both aile and etoile, but that would be 2×((3×2×2×2)+(3×2))=60 images (and then ×3 again for the three different examples below would make it 120 total) so I'm only showing a subset for bandwidth reasons. However, just bear in mind that I tested every permutation.
Firstly, optimize the mid x point when in a digraph ligature (mind you,
𝼜
and𝼙
are still not yet added):Thin Upright:
Regular Upright:
Heavy Upright:
Thin Italic:
Regular Italic:
Heavy Italic:
Secondly, make capital Ezh use full ArchDepth:
ƷʒӠӡzᴣᴢЗз
Thin Upright:
Regular Upright:
Heavy Upright:
Thin Italic:
Regular Italic:
Heavy Italic:
Thirdly, Optimize the ezh terminal for Lezh with retroflex hook:
Thin Upright:
Regular Upright:
Heavy Upright:
Thin Italic:
Regular Italic:
Heavy Italic: