Home
The "Network Module Manual" in Word, ODT, and PDF format is provided with each release. The manual provides detailed instructions on how to program and use the Network Module. Link: https://github.com/nielsonm236/NetMod-ServerApp/releases
If you have specific issues it is best to write them up in the Issues section. Don't worry if they turn out to be minor ... the Issue can always be closed. But writing them up there sometimes helps others as they may have the same questions. Also, you can contact me directly at [email protected].
You should change the IO Type first (Input/Output/Disable/Linked), THEN Save, THEN come back and make changes to the Invert and Boot State settings
You should change the IO Type first (Input/Output/Disable/Linked), THEN Save, THEN come back and make changes to the Invert and Boot State settings.
If you add a PCF8574 IO Expander the following applies to Browser Only and MQTT Home Assistant firmware:
You should change the IO Type first (Input/Output/Disable/Linked), THEN Save, THEN come back and make changes to the Invert and Boot State settings
You should change the IO Type first (Input/Output/Disable/Linked), THEN Save, THEN come back and make changes to the Invert and Boot State settings.
You should change the IO Type first (Input/Output/Disable/Linked), THEN Save, THEN come back and make changes to the Invert and Boot State settings.
A YouTube video (updated 5/9/2021) is available that demonstrates the re-programmed module and shows how to do the programming. The video is slightly outdated so I recommend using the instructions in the video with regard to finding and installing the programming files. See the video at https://youtu.be/cnLHd9GqplY