Ender-3 V3 SE (Klipper Config and Macros)

This repository contains the Klipper configuration and macros for the Ender 3 V3 SE.

Klipper Installation Guide

Follow this guide to install Klipper on your Ender 3 V3 SE: Klipper Installation Guide

Note

The guide uses a different configuration file available here: Bootuz-Dinamon Ender 3 V3 SE Klipper Config
However, my configuration is derived from it, with several issues fixed and improved macros. You are free to use either configuration based on your preference.

Slicer Setup

Start G-Code (OrcaSlicer/Creality Print)

PRINT_START BED=[bed_temperature_initial_layer_single] EXTRUDER=[nozzle_temperature_initial_layer]

Start G-Code (Cura)

PRINT_START BED={material_bed_temperature} EXTRUDER={material_print_temperature}

End G-Code

PRINT_END