tpm: fix Atmel TPM crash caused by too frequent queries

The Atmel TPM 1.2 chips crash with error
`tpm_try_transmit: send(): error -62` since kernel 4.14.
It is observed from the kernel log after running `tpm_sealdata -z`.
The error thrown from the command is as follows
```
$ tpm_sealdata -z
Tspi_Key_LoadKey failed: 0x00001087 - layer=tddl,
code=0087 (135), I/O error
```

The issue was reproduced with the following Atmel TPM chip:
```
$ tpm_version
T0  TPM 1.2 Version Info:
  Chip Version:        1.2.66.1
  Spec Level:          2
  Errata Revision:     3
  TPM Vendor ID:       ATML
  TPM Version:         01010000
  Manufacturer Info:   41544d4c
```

The root cause of the issue is due to the TPM calls to msleep()
were replaced with usleep_range() [1], which reduces
the actual timeout. Via experiments, it is observed that
the original msleep(5) actually sleeps for 15ms.
Because of a known timeout issue in Atmel TPM 1.2 chip,
the shorter timeout than 15ms can cause the error described above.

A few further changes in kernel 4.16 [2] and 4.18 [3, 4] further
reduced the timeout to less than 1ms. With experiments,
the problematic timeout in the latest kernel is the one
for `wait_for_tpm_stat`.

To fix it, the patch reverts the timeout of `wait_for_tpm_stat`
to 15ms for all Atmel TPM 1.2 chips, but leave it untouched
for Ateml TPM 2.0 chip, and chips from other vendors.
As explained above, the chosen 15ms timeout is
the actual timeout before this issue introduced,
thus the old value is used here.
Particularly, TPM_ATML_TIMEOUT_WAIT_STAT_MIN is set to 14700us,
TPM_ATML_TIMEOUT_WAIT_STAT_MIN is set to 15000us according to
the existing TPM_TIMEOUT_RANGE_US (300us).
The fixed has been tested in the system with the affected Atmel chip
with no issues observed after boot up.

References:
[1] 9f3fc7b tpm: replace msleep() with usleep_range() in TPM
1.2/2.0 generic drivers
[2] cf151a9 tpm: reduce tpm polling delay in tpm_tis_core
[3] 59f5a6b tpm: reduce poll sleep time in tpm_transmit()
[4] 424eaf9 tpm: reduce polling time to usecs for even finer
granularity

Fixes: 9f3fc7b ("tpm: replace msleep() with usleep_range() in TPM 1.2/2.0 generic drivers")
Link: https://patchwork.kernel.org/project/linux-integrity/patch/[email protected]/
Signed-off-by: Hao Wu <[email protected]>
Reviewed-by: Jarkko Sakkinen <[email protected]>
Signed-off-by: Jarkko Sakkinen <[email protected]>

drivers/char/tpm/tpm_tis_core.c

@@ -48,6 +48,7 @@ static int wait_for_tpm_stat(struct tpm_chip *chip, u8 mask,
 		unsigned long timeout, wait_queue_head_t *queue,
 		bool check_cancel)
 {
+	struct tpm_tis_data *priv = dev_get_drvdata(&chip->dev);
 	unsigned long stop;
 	long rc;
 	u8 status;
@@ -80,8 +81,8 @@ static int wait_for_tpm_stat(struct tpm_chip *chip, u8 mask,
 		}
 	} else {
 		do {
-			usleep_range(TPM_TIMEOUT_USECS_MIN,
-				     TPM_TIMEOUT_USECS_MAX);
+			usleep_range(priv->timeout_min,
+				     priv->timeout_max);
 			status = chip->ops->status(chip);
 			if ((status & mask) == mask)
 				return 0;
@@ -945,7 +946,22 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 	chip->timeout_b = msecs_to_jiffies(TIS_TIMEOUT_B_MAX);
 	chip->timeout_c = msecs_to_jiffies(TIS_TIMEOUT_C_MAX);
 	chip->timeout_d = msecs_to_jiffies(TIS_TIMEOUT_D_MAX);
+	priv->timeout_min = TPM_TIMEOUT_USECS_MIN;
+	priv->timeout_max = TPM_TIMEOUT_USECS_MAX;
 	priv->phy_ops = phy_ops;
+
+	rc = tpm_tis_read32(priv, TPM_DID_VID(0), &vendor);
+	if (rc < 0)
+		goto out_err;
+
+	priv->manufacturer_id = vendor;
+
+	if (priv->manufacturer_id == TPM_VID_ATML &&
+		!(chip->flags & TPM_CHIP_FLAG_TPM2)) {
+		priv->timeout_min = TIS_TIMEOUT_MIN_ATML;
+		priv->timeout_max = TIS_TIMEOUT_MAX_ATML;
+	}
+
 	dev_set_drvdata(&chip->dev, priv);
 
 	if (is_bsw()) {
@@ -988,12 +1004,6 @@ int tpm_tis_core_init(struct device *dev, struct tpm_tis_data *priv, int irq,
 	if (rc)
 		goto out_err;
 
-	rc = tpm_tis_read32(priv, TPM_DID_VID(0), &vendor);
-	if (rc < 0)
-		goto out_err;
-
-	priv->manufacturer_id = vendor;
-
 	rc = tpm_tis_read8(priv, TPM_RID(0), &rid);
 	if (rc < 0)
 		goto out_err;

drivers/char/tpm/tpm_tis_core.h

@@ -54,6 +54,8 @@ enum tis_defaults {
 	TIS_MEM_LEN = 0x5000,
 	TIS_SHORT_TIMEOUT = 750,	/* ms */
 	TIS_LONG_TIMEOUT = 2000,	/* 2 sec */
+	TIS_TIMEOUT_MIN_ATML = 14700,	/* usecs */
+	TIS_TIMEOUT_MAX_ATML = 15000,	/* usecs */
 };
 
 /* Some timeout values are needed before it is known whether the chip is
@@ -98,6 +100,8 @@ struct tpm_tis_data {
 	wait_queue_head_t read_queue;
 	const struct tpm_tis_phy_ops *phy_ops;
 	unsigned short rng_quality;
+	unsigned int timeout_min; /* usecs */
+	unsigned int timeout_max; /* usecs */
 };
 
 struct tpm_tis_phy_ops {

include/linux/tpm.h

@@ -269,6 +269,7 @@ enum tpm2_cc_attrs {
 #define TPM_VID_INTEL    0x8086
 #define TPM_VID_WINBOND  0x1050
 #define TPM_VID_STM      0x104A
+#define TPM_VID_ATML     0x1114
 
 enum tpm_chip_flags {
 	TPM_CHIP_FLAG_TPM2		= BIT(1),